Understanding powder degradation in metal additive manufacturing to allow the upcycling of recycled powders

Powell, Dan and Rennie, Allan and Geekie, Louise and Burns, Neil (2020) Understanding powder degradation in metal additive manufacturing to allow the upcycling of recycled powders. Journal of Cleaner Production, 268: 122077. ISSN 0959-6526

[thumbnail of Review Article for Apr 2020 submission]

Text (Review Article for Apr 2020 submission)
Review_Article_for_Apr_2020_submission.pdf - Accepted Version
Available under License Creative Commons Attribution-NonCommercial-NoDerivs.
Download (771kB)

Abstract

To ensure the financial viability of powder-based additive manufacturing technologies, the recycling of powders is common practice. This paper shows the lifecycle of metal powder in additive manufacturing, investigating powder manufacture, powder usage, mechanisms of powder degradation and the usage of end-of-life powder. Degradation of powders resulting from repeated reuses was found to be a widespread problem; components produced from heavily reused powders are typically of a lower quality, eventually rendering the powder unusable in additive manufacturing. Powder degradation was found to be dependent on many variables, preventing the identification of a definitive end-of-life point for powders. The most accurate method of determining powder quality was found to be the production and analysis of components using these powders. Uses for degraded powder had not been previously identified in literature, warranting the investigation of potential solutions to prevent powder waste. Amongst other waste-reducing solutions, plasma spheroidisation was identified as a promising method to avoid powder disposal for approximately 12.5% of produced powders, creating particles similar to virgin powder from end-of-life powder. Returning end-of-life powders to the supplier for upcycling may be the only financially viable solution to reduce waste within the industry. The compilation of research within this paper aims to enable users of additive manufacturing to conduct further research and development into powder upcycling.

Item Type:

Journal Article

Journal or Publication Title:

Journal of Cleaner Production

Additional Information:

This is the author’s version of a work that was accepted for publication in Journal of Cleaner Production. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in Journal of Cleaner Production, 268, 2020 DOI: 10.1016/j.jclepro.2020.122077

Uncontrolled Keywords:

/dk/atira/pure/subjectarea/asjc/2300/2300

Subjects:

?? additive manufacturingmetallurgypowder degradationupcyclingplasma spheroidisationgeneral environmental sciencestrategy and managementindustrial and manufacturing engineeringrenewable energy, sustainability and the environmentenvironmental science(all) ??

Departments:

Faculty of Science and Technology > Engineering

ID Code:

143926

Deposited By:

ep_importer_pure

Deposited On:

12 May 2020 08:25

Refereed?:

Yes

Published?:

Published

Last Modified:

18 Sep 2024 00:56

URI:

https://eprints.lancs.ac.uk/id/eprint/143926