Strength-based Design Analysis of a Para-Plow Tillage Tool

Celik, H. Kursat and Caglayan, Nuri and Topakci, Mehmet and Rennie, Allan and Akinci, Ibrahim (2020) Strength-based Design Analysis of a Para-Plow Tillage Tool. Computers and Electronics in Agriculture, 169: 105168. ISSN 0168-1699

Text (Design_Analysis_of_a_Paraplow_Rev_007_smaller_image_size_1_)
Design_Analysis_of_a_Paraplow_Rev_007_smaller_image_size_1_.pdf - Accepted Version
Available under License Creative Commons Attribution-NonCommercial-NoDerivs.
Download (14MB)

Abstract

In this research, experimental field tests and an advanced computer aided design and engineering (CAD and CAE) based application algorithm was developed and tested. The algorithm was put into practice through a case study on the strength-based structural design analysis of a Para-Plow tillage tool. Para-Plow is an effective tractor attached tillage tool utilised as an alternative to the conventional deep tillage tools used in agricultural tillage operations. During heavy tillage operations, the Para-Plow experiences highly dynamic soil reaction forces which may cause undesired deformations and functional failures on its structural elements. Here, prediction of the deformation behaviour of the tool structure during tillage operation in order to describe optimum structural design parameters for the tool elements and produce a functionally durable tool become an important issue. In the field experiments, draft force and strain-gauge based measurements on the tool were carried out simultaneously. Subsequently, Finite Element Method based stress analysis (FEA) were employed in order to simulate deformation behaviour of the tool under consideration of the maximum loading (worst-case scenario) conditions tested in the field. In the field experiments, average and maximum resultant draft forces were measured as 33,514 N and 51,716 N respectively. The FEA revealed that the maximum deformation value of the tool was 9.768 mm and the maximum stress values impart a change on the most critical structural elements of between 50 and 150 MPa under a worst-case loading scenario. Additionally, a validation study revealed that minimum and maximum relative differences for the equivalent stress values between experimental and simulation results were 5.17% and 30.19% respectively. This indicated that the results obtained from both the experimental and simulation are reasonably in union and there were no signs of plastic deformation on the Para-Plow elements (according to the material yield point) under pre-defined loading conditions and a structural optimisation on some of the structural elements may also be possible. This research provides a useful strategy for informing further research on complicated stress and deformation analyses of related agricultural equipment and machinery through experimental and advanced CAE techniques.